Rental Equipment
for Specialist Companies
We don't just take measurements ourselves. We also rent out our equipment to specialist companies, i.e. plumbers or other engineering firms, on request. Since most measuring devices require extensive know-how to use them properly and effectively, we do not rent our equipment to end customers. Of course, any end customer can commission us to perform the measurement service or send their specialist company to us to borrow the device. In turn, we offer specialist companies not only the device, but also specialist advice on problem areas and support to ensure that the data can be evaluated, so that the person taking the measurements does not just measure rubbish and, in the worst case, does not even notice. Of course, we only lend to knowledgeable persons and require conscientious handling of the devices. If there is any uncertainty, we offer training and device introductions.
Multiparameter Probe MS5
for the autonomous recording of:
Water level, pH value, temperature, conductivity, redox potential and optionally oxygen or turbidity
integrated battery and data logger
Do you want to monitor water levels, determine the intensity of fluctuations in water quality, or detect possible surface water ingress into your well or spring shaft during rainfall? No problem. This multi-parameter probe measures and transmits the data directly to your PC, or you can store it independently and evaluate the data later in the office. Our probes may only be used in clean surface water or drinking water areas. The most accurate measurement technology for the best medium.
Mobile Flow Measurement
in closed/filled pipes using ultrasound
Kawimeter
Transmission
SSK 254nm
Whether you want to hydraulically balance your heating system or design a new solar system for heating drinking water according to your hot water requirements, which you first need to determine... no problem. Or maybe you should descale the heat exchanger because it is almost stuck due to limescale deposits, or you suspect that the riser pipe is blocked, which is why the temperatures in the circulation line are not rising, but could it also be a branch on the floor that is causing the problem? It's amazing what you can find out when you know the volume flow or the speed.
In order to design a UV system, it makes sense to know the UV transmission properties of the water. These can vary considerably, so it makes sense to borrow a device for a few days and then simply take measurements at different times, even at different times of the year, if you have to assume that the situation may worsen.
Of course, when troubleshooting poor radiation intensities, measuring transmission also provides reliable information that it cannot be due to the raw water, for example.